07506 518 646

Visonic and Orisec alarm engineer

Visonic and Orisec alarms installed, serviced, repaired, reset and upgraded, and any other make and model of burglar alarm too.

Call Dean 07506 518 646Get a quote
A wireless alarm control panel with a lit keypad fitted by DF Alarms on a hallway wall

Visonic and Orisec are two of the alarm makes Dean works with most. Visonic is best known for its wireless systems, and Orisec makes wired and wireless panels, keypads and bell boxes that are widely fitted in UK homes.

Whether you want a new Visonic or Orisec system, or an existing one serviced, repaired or brought back under your control, DF Alarms covers Wigan and the towns around it. And if your alarm is a different make entirely, that is fine too: any make, any model can be serviced.

What we do on Visonic and Orisec systems

Panel beeping or showing a fault?

A beeping Visonic or Orisec panel is usually reporting a trouble condition rather than an alarm: a low battery in a sensor or the panel, a wireless device that has lost contact, a power cut or a tamper fault. The keypad normally says which.

Take a photo of the message and ring 07506 518 646. Dean can often tell you over the phone what it means, and fix the cause rather than just silencing it.

Fitting a new backup battery into an alarm control panel

Any make, any model serviced

Visonic, Orisec or something else entirely, fitted by Dean or by a company that closed years ago: every service comes with 12 months’ free call-out cover for faults (parts not included).

Visonic and Orisec questions

All questions

Will you service or repair an alarm someone else fitted?

Yes. A lot of the alarms we look after were fitted by another company, sometimes one that no longer exists. Most systems can be serviced, repaired or brought back under your control, and if a panel really has had its day we will tell you honestly and quote for an upgrade.

Do wireless alarm sensors need new batteries?

Yes, every few years. Each wireless sensor and contact has its own long-life battery, and the panel warns you well before one runs flat, usually with a message on the keypad and a beep. Batteries are checked and replaced as part of an alarm service.

My Visonic or Orisec alarm keeps beeping. What does it mean?

A beeping panel is usually reporting a trouble condition rather than an alarm: a low battery in a sensor or the panel, a wireless device that has lost contact, a power cut, or a tamper fault. The keypad normally shows which. Dean can read the fault, fix the cause and clear it so it stops.

Visonic and Orisec alarms around Wigan

We service and repair Visonic, Orisec and other alarms across all of these towns.

All areas we cover

Get your Visonic or Orisec alarm sorted

Tell Dean the make, what the keypad says and roughly where you are. A photo of the panel or keypad helps.

100% recommend235 reviews on Facebook
For example: three-bed semi, old alarm keeps going off and we do not know the code. Or: two cameras covering the drive and back door.
A photo of your keypad, panel or bell box helps Dean see what you have.

No obligation. Your details are only used to reply to you. Privacy policy.

WhatsApp Dean Call 07506 518 646